Jet Mill Complete Rebuild
A Customer asked WBA if they could rebuild a Jet Mill which included:
- Sand Blasting
- Painting
- Moving and/or Plugging Feed Pipes
- All New Hardware, Seals, Belts, O Rings, Pistons, Door Switches and Compensators
- Fabricating New Mounting Arms, Stand, and Guard for Belts
- Rebalancing Classifier Wheel
- Refurbishing Bearing Housing & Motor
- Running Mill at 25/50/75/100 Percent for 8 hours
- Building and Wiring Control Enclosure
- Drawing for Control Enclosure
-
- This is the Jet Mill when entered our shop
-
- Plasma Cut Tube off the Top Lid of Jet Mill
-
- Plasma Cut Tube off the Top Lid of Jet Mill
-
- Welded Cap on the Lid
-
- Sand Blasted Lid
-
- Sand Blasted Mid Section
-
- Sand Blasted Ring
-
- Painted Lid
-
- Painted Mid Section
-
- Painted Ring
-
- Painted Bottom of Jet Mill
-
- Fab Square Stand made from 6″ x 6″ Steel Tubing
-
- Partially Assembled and Painted Jet Mill
-
- Partially Assembled and Painted Jet Mill with Stand
-
- Partially Assemble Jet Mill with Covers
-
- Partially Assemble Jet Mill with Arms
-
- Jet Mill Belt Guard
-
- Jet Mill Partial Assembly Ready for Motor Testing
-
- Jet Mill Complete Assembly with Compensators
-
- Jet Mill Complete Assembly with Compensators
-
- Jet Mill Control Enclosure Door with Purge System
-
- Jet Mill Control Enclosure Door with Purge System
-
- Jet Mill Controls
